4-14
4.2.4 Setting a model
The model is set.
When the model is set, the setting contents are initialized.
When setting up to "GPS" by model setup, perform receiver selection like the first time power ON (refer
to "4.1.1 Turning on the power").
Procedure
1. Refer to “4.2.3Changing to a maintenance mode” to display the maintenance menu.
2. Select “DISPLAY TYPE” by using
and press .
3. Select “MID”, "LOG" or "GPS" by using
and press .
4. When the following popup menu is displayed, press “YES”.
When “NO” is selected, the model setting is cancelled.
・When "LOG" is selected by mistake, the following messages appears.
After the messages appears, press and for 8 seconds. The
message is canceled.
Then, select "MID" or "GPS" again in the previous procedure.
・Don't turn off the power supply until the "INITIALIZING" disappears.
Supplement
Please turn on
the power again.
To Next Page
Loading...
