4-19
Main menu
Explanation
Default
Sub-menu1
Sub-menu2
Sub-menu3
DEMO MODE To start demonstration, set to "START".
To end demonstration, set to "END".
・
During execution of demonstration, [S] is displayed
in blinking mode at the bottom of the screen.
-
11> SOFT UPDATE
DISPLAY
Display program update. -
12> DISPLAY TYPE
Setting a model.
・When the model is set, the setting contents are
initialized.
MID
13> RS-485ID
To identify a display unit on the RS-485 network, set
an ID for each display unit.
Avoid duplication of ID among the display units.
【 1～10 】
1
14> DIMMER GROUP
Dimmer control linkage is available for the display
units that are connected by the RS-485 network.
・The display of same dimmer group number can be
linked.
【 1～10 】
1
15> DIMMER
Selecting a dimmer unit.
【Key(DIM key), EXT DIMMER(External dimmer unit)】
Key
16> CURRENT
Setting the current layer and data No. to be displayed.
・The layer that can be displayed is up to three layers
from the top.
【 LAYER, DATA No. 】
LAYER
To Next Page
Loading...
