Section 9 Route Planning 9-24
Memo
The maximum latitude input range of Position is 85 ° 00.000 (polar range restriction).
3 Set the following items as required.
*Some items are for display only and cannot be set.
Item Description
[Name] Set a name of WPT.
[Leg BWW] This is the bearing from the previous WPT and is not set in
WPT0. The specifiable range is from 0.0° to 359.9°.
Editing is disabled when [GC] is selected in [Sail].
[Leg Distance] This is the distance from the previous WPT and is not set in
WPT0. The specifiable range is from 0.0 to 9999.9 NM.
Editing is disabled when [GC] is selected in [Sail].
[Sail] [RL] or [GC] can be selected from the list.
[XTD PORT] (Port side cross
track limit)
Set a port side cross track limit. The specifiable range is from
0.01 to 9.99 NM.
[XTD STBD] (Starboard side
cross track limit)
Set a starboard side cross track limit. The specifiable range is
from 0.01 to 9.99 NM.
[Arrival Radius] Sets the arrival radius. (0.01 to 9.99 NM)
[Turning Radius] (Turning
radius)
Sets the turning radius. (0.00 to 9.99 NM)
[Planned Speed] (Planned
speed)
Sets the planned ship’s speed. (1.0 to 99.9kn)
[ROT] ROT is automatically calculated from the planned speed and
turning radius.
[ETA] ETA is automatically calculated from the position of WPT,
planned speed, and time zone.
[Time Zone] The time difference of the time of arrival can be input within
the range from -13.30 to +13.30.
[TWOL] TTG can be automatically calculated from the position of WPT
and planned speed.
※[Setting]-[Route]-[Monitoring]-[Arrivalcircle] selected:[TTG]
[Total Distance] This is the total distance between WPT0 and the final WPT.
Memo
The values that are set by selecting [Settings] – [Route] on the menu is reflected in [Sail],
[XTD PORT], [XTD STBD], [Arrival radius], [Turning Radius], [Planned Speed], and [Time
Zone]. For the details, refer to "18.12 Setting parameter values for automatic sailing ".
To Next Page
Loading...
