JRC JMR-7230-S - Changing XTD (Cross Track Limit)

Section 9 Route Planning 9-46
9.7.3.3 Changing XTD (cross track limit)
1 Click on the XTD.
The cursor is changed to the XTD change mode.
2 Move the cursor and change the XTD.
Use the information (XTD distance) that is displayed near the cursor and the line that is linked to
the cursor as the guideline.
Note
The line cannot be moved exceeding the limit of XTD (5.00 NM).
3 Click the mouse button.
The width of the XTD is changed.
Cancelling the operation
The change operation can be cancelled by clicking the right button instead of clicking at Step 3.