JRC JMR-7230-S - Displaying Differences at C-MAP Chart Update

13-37 Section 13 Operating a Chart (option)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
13.14.2 Displaying differences at C-MAP chart
update
When the C-MAP chart is updated, only the updated object of the last Update No. is displayed in
highlight mode.
Since update approval operation is not available for the C-MAP chart, the update object of the last
Update No. is displayed in the usual color immediately after the update.
However, when the [Check Applied C-MAP Updates] dialog is displayed, a highlighted display mark is
displayed overlaying the updated object only for the cell that is selected on the screen.
The following table shows the drawing patterns at the usual state and the drawing patterns of the chart
that is selected in the [Check Applied C-MAP Updates] dialog for each update content.
Update content
Drawing patterns at usual
state
Drawing patterns of the chart that is
selected in [Check Applied C-MAP Updates]
Addition Only the added object is
drawn.
The added object is drawn and highlighted
display is overlaid on the object.
Deletion The deleted object is not
drawn.
The deleted object is not drawn and only
highlighted display is drawn at the position
of the object.
Change Only the changed object is
drawn.
The changed object is drawn and
highlighted display is drawn over the object.