JRC JMR-7230-S - Creating an Object by Specifying the Center Position and the Object Size

14-51 Section 14 Creating a User Chart/ Updating a Chart Manually
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
At creation of an arc, the starting angle and the ending angle of the arc to be created are the
previous values or the initial values (starting angle: 0°, ending angle: 90°). To change the
starting angle and the ending angle, change the values in [Start Angle] and [End Angle] on the
object property dialog box.
5 Determine the object by clicking the button again.
6 Adjust the parameters on the object property dialog box.
7 To create an object on another position continuously, repeat Steps 3 to 6.
14.5.5.1 Creating an object by specifying the center position and
the object size
1
Click on the [Enter POSN] button on the drawing toolbar.
The [Enter Position] dialog box appears (Refer to "14.2.6 Creating an object by specifying
latitude and longitude").
2 Enter the coordinates of the center of the circle, ellipse, or arc and click on the [Enter]
button on the [Enter Position] dialog box.
A center point is created on the position of the specified coordinates and the property
information is reflected in the object property dialog box (Refer to "14.2.8 Object property dialog
box").
3 Set the following parameters on the object property dialog box.
- Circle: Enter a value of [Radius].
- Ellipse: Enter values of [Horizontal] and [Vertical].
- Arc: Enter values of [Radius], [Start Angle], and [End Angle].
4 To create an object on another position continuously as required, repeat Steps 2 and
3.
After determination, the arc is selected and the cursor
moves to the center setting mode for the next arc.
Click the center
position