16-9 Section 16 Setting up Screen View
The descriptions of settings are shown in the table below.
Setting Item Description of Setting Setting Value
Type Select an own ship symbol from the combo box (symbols
of other ships are also linked).
: Auto
: Simplified Symbol
: Outline
: Minimized Symbol
*In Auto, the display is switched between Outline and
Minimized Symbol depending on the size of the symbol.
When the beam side of the Outline symbol is 3mm or
more, the symbol is displayed in Outline and when the
symbol is less than 3mm, it is displayed in Minimized
Symbol.
The beam side is 3mm or more
For RADAR:
AUTO
Outline
Minimized Symbol
[default]
For ECDIS:
Simplified Symbol
[default]
Outline
Heading and
Beam Line
(Heading
line/beam line
display)
Selecting this enables to display heading lines and beam
lines.
Note
This item can only be set on the ECDIS screen.
To enable: Select.
To disable: Clear.
Stern Line Selecting this enables to display a stern line.
Note
This item can only set in the RADAR screen.
To enable: Select.
To disable: Clear.
Ground Stabilised
Vector
Selecting this enables to display a ground stabilised
vector.
To enable: Select.
To disable: Clear.
Sea Stabilised
Vector
Selecting this enables to display a sea stabilised vector. To enable: Select.
To disable: Clear.
Time
(Length of own
ship's vector)
Enter the own ship's vector length in the box. 0 to 120
Stabilization
Indicator
Selecting this enables to display the stabilization
indicator.
Note
When both the Ground Stabilised Vector and the Sea
Stabilised Vector are effective, this automatically takes
effect.
To enable: Select.
To disable: Clear.
Vector Time Mark Selecting this enables the interval of the vector time
mark.
To enable: Select.
To disable: Clear.
To Next Page
Loading...
