Section 16 Setting up Screen View 16-38
Restrictions on [Safety Contour] and [Deep Contour]
1) When entering in [Shallow Contour]
If “Safety Contour < Shallow Contour ≤ Deep Contour”, the Safety Contour value is corrected to the
Shallow Contour value.
If “Safety Depth < Shallow Contour ≤ Deep Contour”, the Safety Contour is corrected to the
Shallow Contour value.
If Safety Contour, Safety Depth ≤ Deep Contour < Shallow Contour”, the Safety Contour, Safety
Depth, and Deep Contour values are corrected to the Shallow Contour value.
2) When entering in [Deep Contour]
If “Shallow Contour ≤ Deep Contour < Safety Contour”, the Safety Contour value is corrected to the
Deep Contour value.
If “Shallow Contour ≤ Deep Contour < Safety Depth”, the Safety Depth value is corrected to the
Deep Contour value.
If “Deep Contour < Shallow Contour ≤ Safety Contour, Safety Depth”, the Safety Contour, Safety
Depth, and Shallow Contour values are corrected to the Deep Contour values.
3) When entering in [Safety Contour]
If “Shallow Contour ≤ Deep Contour < Safety Contour”, the Deep Contour value is corrected to the
Safety Contour value.
If “Safety Contour < Shallow Contour ≤ Deep Contour”, the Shallow Contour value is corrected to
the Safety Contour value.
4) When entering [Safety Depth]
If “Shallow Contour ≤ Deep Contour < Safety Depth”, the Deep Contour value is corrected to the
Safety Depth value.
If “Safety Depth < Shallow Contour ≤ Deep Contour”, the Shallow Contour value is corrected to the
Safety Depth value.
The compensated setting values are flashed temporarily.
To Next Page
Loading...
