JRC JMR-7230-S - 17.3 New Target Warning Generation Conditions

Section 17 Setting up Alerts 17-6
17.3 New Target Warning Generation
Conditions
When you select [New Target Warning] in the classification pane, the [New Target Warning] dialog is
displayed in the edit pane.
In this dialog, it is possible to set the AZ (automatic acquisition/activation zone) and switch the AZ to
enable/disable.
For the details of the setting of the AZ, refer to "6.5.1.1 Automatic acquisition mode".
Start angle
AZ1
AZ2
End angle
End distance
Start distance
Settings of AZ1
(Automatic Acquisition
/Activation
Area 1)
Settings of AZ2
(Automatic Acquisition
/Activation
Area 2)
When one of these is
selected, AZ1 or AZ2 takes
effect.
When this is clicked on, the
cursor mode is set to a Make
AZ mode.
Enter the start angle.
Enter the end angle.
Enter the start distance.
Enter the end distance.