JRC JMR-7230-S - Page 636

Section 18 Setting up the Operation Mode 18-34
18.16 Setting Logbook
Select [Logbook] in the classification pane.
Set Logbook in the setting dialog of the edit pane (ECDIS screen only).
[Logging Events] tab
Setting Item Description of Setting Setting Value
At Noon When this is selected, log data is
saved at 12:00 (LMT).
To enable: Select.
To disable: Clear.
Every ([Logging Events]
tab)
When this is selected, log data is
saved at the interval specified in
the combo box.
<Check box>
To enable: Select.
To disable: Clear.
<Selections in the combo box>
1/3/5/10/15/30/60 min
Event Mark When this is selected, log data is
saved when the EVENT button is
pressed.
To enable: Select.
To disable: Clear.
Manual Position Fix When this is selected, the time,
bearing, position, objects used
during manual position fixing in
cross bearing or running fix are
saved.
To enable: Select.
To disable: Clear.
Chart Manual Updating When this is selected, log data is
saved when the chart is manually
updated.
To enable: Select.
To disable: Clear.