JRC JMR-9230-S3 - Adjusting Tune

5-9 Section 5 Basic Operation of the Radar
1
2
3
4
5
5
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
1
5.3.3 Adjusting tune
Normally, use the automatic tune mode.
If you use the manual tuning mode, an accident may be caused by
fluctuation of transmission and reception.
Use the manual tune mode only when best tuning is not possible in the
automatic tune mode due to deterioration of magnetron.
This equipment has the automatic tuning mode that performs tuning of the transmission frequency and
the reception frequency by automatic control, and the manual tuning mode in which the user performs
tuning. Normally use the automatic tune mode. Only when the best tuning is not possible by the
automatic tune mode due to the deterioration of magnetron, use the manual tune mode.
The tuning mode currently being used is displayed on the Tuning Mode button in Radar system
information.
Note
This function is effective when a magnetron radar antenna is connected.
When using the automatic tune mode
1
Click on the tune mode button.
[AUTO] (automatic) is displayed on the tune mode button.
Whenever the button is clicked on, the mode is switched between [AUTO] (automatic) and
[MAN] (manual).
Tuning Mode button