JRC JMR-9230-S3 - Setting a Dragging Anchor Monitoring Area

Section 11 Monitoring a Dragging Anchor 11-2
11.1 Setting a Dragging Anchor
Monitoring Area
This section describes the setting of a dragging anchor monitoring area.
The setting varies depending on whether the shape of the dragging anchor area is a circle or a
polygon.
11.1.1 Setting a dragging anchor monitoring circle
1 Click on the [Menu] button on the left toolbar.
The menu is displayed.
2 Click on the [Anchor Watch] button on the menu.
The [Anchor Watch] dialog box appears.
3 Select [Circle] from the [Mode] (dragging anchor monitoring mode selection) combo
box.