JRC JMR-9230-S3 - Adjusting an ARCS Chart Position; Offsetting an ARCS Chart

13-15 Section 13 Operating a Chart (option)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
13.8 Adjusting an ARCS Chart Position
Note
Adjust the offet only when the geodetic datum of the chart is a local geodetic datum and the
display position is not adjusted correctly.
13.8.1 Offsetting an ARCS chart
Move the chart by entering offset values (latitude and longitude) or using the cursor.
1 Click on the [Menu] button on the left toolbar.
The menu is displayed.
2 Click on the [Chart] - [Datum Offset] (geodetic offset) on the menu.
The [Datum Offset] (geodetic offset) dialog box appears.
When the previous setting values are displayed in the [Off set] box, the values can be cleared
by clicking on the [Clear Offset] button.
To set offset of a chart, use the cursor or enter offset values.
Offsetting a chart with the cursor
1 Click on the [Offset by Cursor] button.
The button display changes to On and the offset function is enabled.
2 Set the cursor to the reference point and click the mouse button.
To clear the offset values, set the button to Off by clicking on the [Offset by Cursor] button.