JRC JMR-9230-S3 - Adding WPT on the Context Menu

9-47 Section 9 Route Planning
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
9.7.3.4 Adding WPT on the context menu
Add a WPT to WPT0 or the last WPT.
1 Click the right mouse button on WPT0 or the last WPT.
The context menu is displayed.
2 Click [Add WPT] on the context menu.
The cursor changes to the WPT addition mode.
3 Move the cursor on the position of the WPT to be added.
4 Click the mouse button.
WPT is added.
Note
In the case of ARCS, when WPT is specified at a position other than the active chart and
another panel exists at the positon, the panel display changes automatically.
WPT that was added