JRC JMR-9230-S3 - Page 457

14-71 Section 14 Creating a User Chart/ Updating a Chart Manually
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
Creating a vertex by entering the position
1 Click on the [Enter POSN] button on the drawing toolbar.
The [Enter Position] dialog box appears.
2 Enter the values of latitude and longitude of the vertex of the object in the [Position]
box and click on the [Enter] button.
The position of one vertex of the object is determined.
The [Bearing] box and the [Distance] box are enabled.
3 Enter the values of latitude and longitude of the next vertex of the object in the
[Position] box. Alternatively, enter the bearing from the vertex that was determined
immediately previously in the [Bearing] box and the [Distance] input box.
4 Click on the [Enter] button.
5 Determine the positions of 3 or more vertices by repeating Steps 2 to 4.
6 Adjust the parameters on the object property dialog box.
7 To create an object on another position continuously, repeat Steps 2 to 6.
Creating an object with EBL/VRM operation
1 Click on the [EBL/VRM] button on the drawing toolbar.
The cursor changes to the EBL/VRM reference point cursor. (Refer to "14.2.5 Creating an
object in the EBL/VRM mode").
2 Click on the position of the reference point of the EBL/VRM marker.
The EBL/VRM marker is displayed.
3 Placing the EBL/VRM marker on the position of the starting point and click the button.
A vertex is created on the position on which the button was clicked, and the property
information is displayed on the object property dialog box. (Refer to "14.2.8 Object property
dialog box").
Starting point