JRC JMR-9230-S3 - Page 543

16-21 Section 16 Setting up Screen View
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
16.2.8 Setting up Radar Overlay and Transparency
of Echo/Trails
When you select [RADAR] in the classification pane, the [RADAR] dialog is displayed in the edit pane.
The descriptions of settings are shown in the table below.
Setting Item Description of Setting Setting Value
RADAR Overlay The radar overlay display turns ON by
selecting the [RADAR Overlay]
Select the required radar system from
the pull-down menu.
Note
- When this is turned OFF, even the
alerts related to the radar will not be
displayed.
- This item is displayed on the ECDIS
screen if RADAR interface is available.
Without interswitch setting
RADAR1/RADAR2
With interswitch setting
RADAR1 to 8
Transparency of
Echo/Trails
Click on the control on the slider and set
up the transparency of echoes/trails.
0 to 15
0 = Opaque (Nontransparent)
15 = Transparent (Completely
transparent)