JRC JMR-9230-S3 - Setting Radar Signal Processing

Section 18 Setting up the Operation Mode 18-6
18.3 Setting Radar Signal Processing
Set [Signal Process] in the classification pane.
Set various processing methods for radar signals in the setting dialog of the edit pane.
Setting Item Description of Setting Setting Value
Video Latitude Set up the gradation of the radar video. Narrow
Normal
Wide
Super Wide
Video Noise
Rejection
Set up to remove noise and signals which are
considered to be clutters of radar video.
Off
Level1(Low)
Level2(High)
Auto Dynamic Range
Control
When this is selected, the dynamic range is
automatically adjusted.
To enable: Select.
To disable: Clear.
Process Switch Specify a particular area and set up a mode for
performing video processing on the inside and
outside of the particular area.
Off
Range Fix
AUTO
2nd Process Mode Set up a processing mode used in the outside of the
particular area. This is enabled when other than [Off]
is being selected in the Process Switch combo box.
PROC Off
3Scan CORREL
4Scan CORREL
5Scan CORREL
Remain
Peak Hold