JRC JMR-9230-S3 - Page 637

18-35 Section 18 Setting up the Operation Mode
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
Setting Item Description of Setting Setting Value
System Start When this is selected, log data is
saved when the system is started.
To enable: Select.
To disable: Clear.
System Exit When this is selected, log data is
saved when the system is shut
down.
To enable: Select.
To disable: Clear.
Route Alert When this is selected, log data is
saved when a route-related alert is
generated.
To enable: Select.
To disable: Clear.
Chart Alert When this is selected, log data is
saved when a chart-related alert is
generated.
To enable: Select.
To disable: Clear.
Autosail Alert
When this is selected, log data is
saved when an autosail-related
alert is generated.
To enable: Select.
To disable: Clear.
System Alert
When this is selected, log data is
saved when a system-related alert
is generated.
To enable: Select.
To disable: Clear.
MOB Start/Stop
When this item is enabled, MOB
start and MOB stop are recorded.
Enable: Check.
Disable: Uncheck.
[View Filter] tab
Setting Item Description of Setting Setting Value
At noon When this is selected, the events
saved at 12:00 (LMT) are
displayed in the list.
To enable: Select.
To disable: Clear.
Specified Period When this is selected, the events
saved at the interval specified in
[Logging] are displayed in the list.
To enable: Select.
To disable: Clear.
Event Mark When this is selected, the events
saved when the EVENT button
was pressed are displayed in the
list.
To enable: Select.
To disable: Clear.
Manual Position Fix When this is selected, the events
saved during manual position
fixing in cross bearing or running
fix are displayed in the list.
To enable: Select.
To disable: Clear.
Chart Manual Updating When this is selected, the events
saved when the chart was
manually updated are displayed in
the list.
To enable: Select.
To disable: Clear.
System Start When this is selected, the events
saved when the system was
started are displayed in the list.
To enable: Select.
To disable: Clear.
System Exit When this is selected, the events
saved when the system was shut
down are displayed in the list.
To enable: Select.
To disable: Clear.