18-39 Section 18 Setting up the Operation Mode
Setting item Setting contents Setting value
Station – Display
Filtering
Select a base station from which
messages are to be displayed.
By checking the Display Filtering
check box, the check box of each
base station can be checked.
Select a required base station by
checking the check box.
Enable: Check
Disable: Uncheck
Month/Year Only the messages that are received
on the selected month/year are
displayed.
Select a required month/year by
checking the check box.
Enable: Check
Disable: Uncheck
Message – Display
Filtering
Select a type of the messages to be
displayed.
By checking the Display Filtering
check box, the check boxes of
message types can be checked.
Select a required message type by
checking the check box.
Enable: Check
Disable: Uncheck
Message – Filtering
Depend on Position
Whether to perform display filtering
by position is selected.
By checking the Filtering Depend on
Position check box, you can select
detailed filtering conditions.
Enable: Check
Disable: Uncheck
Message – Filtering
Depend on Position –
Range from Own
Ship
Choose whether to perform display
filtering by the distance from the
ship's position.
When checked, filtering is performed
by the distance from the ship's
position to the set value of the Radius
input box.
Enable: Check
Disable: Uncheck
Message – Filtering
Depend on Position –
Radius
Enter the distance of the filter from
your ship.
Click the NM / min button to switch
the unit.
0.1~300 NM
1.0~30.0 min
Message – Filtering
Depend on Position –
Crossing Monitoring
Route
Choose whether to perform display
filtering by route selected during route
monitoring.
When checked, filtering is carried out
by the route monitoring range.
Enable: Check
Disable: Uncheck
Message – Filtering
Depend on Position –
Crossing Planning
Route
Choose whether to perform display
filtering by route selected during route
planning.
When checked, filtering is carried out
by the route planning range.
Enable: Check
Disable: Uncheck
To Next Page
Loading...
