ā 96 ā
1. Adjustment of roller stacker setup
(1) Parallelism check
Confirm that the stacker table and the rubber roller are mounted
in parallel to each other.
If the parallelism is not secured, adjust it by loosening four setscrews
.
(2) Clearance check
Confirm that a clearance of about 0.5mm is secured between the
stacker table and the rubber roller .
If this clearance of 0.5mm is not secured, adjust it by loosening the
nut .
* According to the thickness of materials, make fine adjustments of
this clearance.
2. Right/left adjustment of the rubber roller
(1) There is a screw in the flat part of the shaft inside the rubber roller
. When this screw is loosened, the rubber roller can be moved
to the right and left.
(2) According to the material length, move the rubber roller and tighten
the screw .
3. Adjustment of backlash
(1) Loosen three setscrews and take out the gearbox lid .
(2) The worm gear is directly coupled with the motor shaft. When
four motor setscrews are loosened, the worm gear can be freely
moved by moving the motor.
(3) Adjust backlash by making the worm gear mesh with the worm
wheel .
(4) Since then, install the motor with the setscrew and the gearbox
lid with the setscrew .
Adjustment Procedures Results of Improper Adjustment
To Next Page
Loading...
