Selection of mode change-over button display in the pattern list screen - - -
Mode change-over button is displayed in the pattern list screen and data of
different mode can be selected.
Non-display Display
Feeding length after sewing endless zipper 0 to 100 50mm
Adjust the length so as to easily perform zipper cut. /
* It is possible to set only when endless zipper device is mounted. 1mm
Clamp foot motor origin compensation -10.0 to 10.0 0.0mm
Origin of clap foot motor is compensated. /
0.1mm
Corner knife motor origin compensation -5.0 to 5.0 0.0mm
Origin of corner knife motor is compensated. /
0.1mm
Marking light origin compensation (just under) -500 to 500 0pulse
Origin of marking light motor is compensated. Origin is in the sate that it /
irradiates light just under and located at the position of 230mm from needle. 1pulse
Marking light origin compensation (needle side) -500 to 500 0pulse
Position of needle side from origin of marking light motor is compensated. /
Light irradiation position 80mm from needle. 1pulse
Marking light origin compensation (operator side) -500 to 500 0pulse
Position of operator side from origin of marking light motor is compensated. /
Light irradiation position is 380mm from needle 1pulse
Back tuck motor origin compensation -30 to 30 0pulse
Origin of back tuck motor is compensated. /
1pulse
Setting range
No. Item / Initial value
Edit unit
ā 105 ā
......... Item that is not displayed due to other setting start.
To Next Page
Loading...
