– 32 –
When the cloth detection sensor detects "absence of material". the sewing state shifts to the "no material
state".
⑨
Cloth puller runs on the multi-layered section of material
Setting of the sewing data to be used while the cloth
puller runs on the multi-layered section of material is
carried out.
State display on the operation panel:
* Depending on the " S017 The number of stitch-
es to be sewn on the multi-layered section" and
"S068 The number of stitches at which the cloth
puller runs on the multi-layered section", the state
of the presser foot side may remain in the "state
of sewing the multi-layered section of material".
The following data items are used.
S004 Limit of sewing speed
S078 Presser foot pressure when the cloth puller runs on the multi-layered section
S071 Cloth puller pressure when the cloth puller runs on the multi-layered section
S070 Cloth pulling amount when the cloth puller runs on the multi-layered section
S068 Number of stitches at which the cloth puller starts running on the multi-layered section
S069 Number of stitches during which the cloth puller runs on the multi-layered section
* If the stitch gathering occurs at the multi-layered section of material in the cloth puller, change the
setting appropriately.
After the sewing machine completes sewing of "S069 The number of stitches during which the cloth puller
runs on the multi-layered section" in the "cloth puller runs on the multi-layered section" state, the sewing
state shifts to the state of the "at section of material".
⑩
Flat section
State display on the operation panel:
The following data items are used.
S004 Limit of sewing speed
S005 Presser foot pressure
S007 Cloth puller pressure
S006 Cloth pulling amount
To Next Page
Loading...
Need help?
General
