– 39 –
4-4-8. List of sewing data
(1) Sewing data to be used for free sewing patterns and step sewing patterns
No. Item name Input range
S001 Shape Free sewing Step
sewing
S003 Stitch length
1.4 to
4.2mm
Enter the stitch length according to the feed amount of
sewing machine. (The feed amount of the sewing ma-
chine will not change if this value is changed.)
S004
*1
Limit of sewing speed
150 to
5500sti/min
‐
S005
*2
Presser foot pressure
–
350 to
200
‐
S006 Cloth pulling amount
1.2 to
5.5mm
‐
S007
*3
Cloth puller pressure
–
90 to
120
‐
S011 Multi-layered section
changeover ON sensor
value
500 to
3000
／
Multi-layered
section is not
detected
- If the multi-layered section sensor value exceeds this
value, the multi-layered section is detected.
S012
*1
Multi-layered section
sewing speed
150 to
5500sti/min
-
This data item is used for setting the sewing speed to be
applied from the time at which the multi-layered section
is detected to the time at which the multi-layered section
sewing ends.
S013 Number of stitches when
the presser foot runs on
the multi-layered section
0 to 200
stitches
-
This data item is used for setting the number of stitches
to be sewn from the time at which the multi-layered sec-
tion of material is detected to the time at which the entire
presser foot runs on the multi-layered section.
While the sewing machine is engaged in the sewing of
this number of stitches, the sewing machine operates
using the cloth pulling amount set with "S015" and the
cloth puller pressure set with "S016".
S015 Cloth pulling amount
when the presser foot
runs on the multi-layered
section
1.2 to
5.5mm
-
S016
*3
Cloth puller pressure
when the presser foot
runs on the multi-layered
section
–
90 to
160 -
*1: The actual sewing speed is limited by "S003 Stitch length" and the set value of cloth pulling amount.
In the case the set value of stitch length is 3.1 mm or more: Maximum sewing speed 5000 sti/min
In the case the set value of cloth pulling amount is 4.6 mm or more: Maximum sewing speed 4000 sti/min
*2: If this value is set to a negative value (minus value), the presser foot will go up. If the presser foot height is set so
that it oats, the multi-layered section changeover function will be disabled.
*3: If this value is set to a negative value (minus value), the cloth puller will go up.
To Next Page
Loading...
Need help?
General
