– 44 –
4-5. How to edit/check the data other than sewing data
The screen for editing/checking the various data is invoked by selecting the menu on the mode screen.
<Mode screen>
①
How to invoke the mode screen.
②
Selecting the menu.
Then, keep
❸
held pressed for three sec-
onds to display the mode screen
.
Select the target menu by pressing
❺
.
When
❼
is pressed during selection of a menu, the following screen can be called.
1. Memory switch............................Refer to
"4-5-1. Memory switch data" p. 45
for details.
2. Counter setting ...........................Refer to
"4-5-2. Counter function" p. 50
for details.
3. Sewing pattern management......Refer to
"4-5-3. How to copy / newly create a pattern" p. 54
for de-
tails.
4. Maintenance setting ...................Refer to
"4-5-4. How to use the warning function" p. 56
for details.
5. F key registration ........................Refer to
"4-5-5. How to use the F key" p. 59
for details.
6. Version display ...........................Refer to
"4-5-6. Checking the version information" p. 62
for details.
7. Contrast setting ..........................Refer to
"4-5-7. Adjusting the contrast of the LCD of the operation
panel" p. 62
for details.
8. Communication...........................Refer to
"4-5-8. Communication function" p. 63
for details.
For the functions which are not described in this manual, only the maintenance personnel is allowed
to operate while referring to the Engineer's Manual since operating those functions can lock up the
sewing machine or can cause unforeseen accidents.
❸
❺
❼
To Next Page
Loading...
Need help?
General
