JUKI SC-921 - 2. Installing the Control Panel

– 2 –
2. Installing the control panel
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and a lapse of 5 minutes or more.
1) Remove side plate setscrews
1
from the side
plate.
1
2) Install control panel
2
on the machine head using
screws
5
, at washers
3
and rubber seat
4
sup-
plied with the control panel as the accessories.
(Caution) 1. DDL-9000B (Not provided with AK)
is given as an example of installing
procedure.
2. Screw to install the panel changes
according to the machine head
used. Refer to Table1 and conrm
the kind of screw.
2
4
5
3
< The relation between the respective machine heads and the positions of installing hole of
the bracket are as described in the table. >
Installing
hole
Screw
DDL-9000B
1
-
5
(Provided with AK)
M5 X 14
Side plate
setscrew
(Not provided with AK)
M5 X 12
LH-3500A
2
-
5
M5 X 14
Side plate
setscrew
DLN-9010
2
-
5
3/16-28 L=12
Screw supplied
with panel as
accessories
DDL-8700 series
3
-
5
3/16-28 L=12
Screw supplied
with panel as
accessories
DDL-5500 series
*1
3
-
5
3/16-28 L=12
Screw supplied
with panel as
accessories
LZ-2280 series
*1
3
-
5
11/64-40 L=7.8
Screws supplied
with machine head
Table 1
*1
For the DDL-5556 and LZ-228*, the machine
head is supplied with an auxiliary bracket for
mounting the control panel as an accessory. Be
sure to install the bracket while referring to the
instruction manual for the machine head.
1
2
5 63
4
(Caution) 1. Screws to be used for installing the panel differ with the machine head, i.e., screws sup-
plied with the panel as accessories and the side plate setscrews. Select appropriate
screws/setscrews referring to Table 1.
2. If the screw type is not correct, the tapped hole can be collapsed.
3. If you want to install the panel on the DDL-8700, be aware that the method to install it on the ma-
chine head differs depending on whether or not the machine head is provided with the AK device.
Machine head with the AK device: Install the panel on the head bracket supplied with the AK.
 (Theauxiliarybracketshouldbexedwiththesideplatesetscrews.)
Machine head without the AK device: Remove the side plate setscrews and install the panel
on the side plate using the screws supplied with panel as accessories.
4. If you want to use the panel with the machine head for heavy-weight materials, install it re-
ferring to the "Supplementary Instructions" for the machine head.