Julabo FP52-SL - Status Messages; Error Messages

Remote control
92
Command Parameter Response of circulator
IN_MODE_01
none Selected setpoint:
0 = Setpoint 1
1 = Setpoint 2
2 = Setpoint 3
IN_MODE_02
none Selftuning type:
0 = Selftuning “off”
1 = Selftuning “once”
2 = Selftuning “always”
IN_MODE_03
none Type of external programmer input:
0 = Voltage 0 V to 10 V
1 = Current 0 mA to 20 mA
IN_MODE_04
none
Internal/external temperature control:
0 = Temperature control with internal sensor.
1 = Temperature control with external Pt100 sensor.
IN_MODE_05
none
Circulator in stop/start condition:
0 = stop
1 = start
IN_MODE_08
none
Adjusted control dynamics
0 = aperiodic
1 = standard
IN_HIL_00
none Max. cooling power (%).
IN_HIL_01
none Max. heating power (%).
12.4. Status messages
Status messages Description
00 MANUAL STOP
Circulator in „OFF“ state.
01 MANUAL START
Circulator in keypad control mode.
02 REMOTE STOP
Circulator in „r OFF“ state.
03 REMOTE START
Circulator in remote control mode.
12.5. Error messages
Error messages
Description
-01 LOW LEVEL ALARM
Low liquid level alarm
-02 REFRIGERATOR ALARM
Control cable of the refrigerated circulator or MVS
solenoid valve controller short-circuited or disconnected.
-03 EXCESS TEMPERATURE
WARNING
High temperature warning
-04 LOW TEMPERATURE WARNING
Low temperature warning.
-05 WORKING SENSOR ALARM
Working temperature sensor short-circuited or
disconnected.