3 Operation and visualisation
40
General For the report:
- If the printing recorder is switched off at the end of the statistical period,
then the print-out will be completely cancelled.
The same applies if the instrument is re-configured from the keys, or if the
setup connector is plugged in.
- If the print-out of a report has been interrupted by a stop, new configura-
tion, setup, print test or service print, then the recording will not be contin-
ued after the recording has restarted.
- If the recorder is in the stop status at the time when the print-out should
begin, then the report will be printed after the stop has been removed.
The statistics for the new report will already be compiled from the originally
planned time.
Sample report The recorder is configured with the report type “periodic”, “time: 7:00 hrs.“
and “interval: 24hrs.”. This means than the statistical period ends, and the re-
sults are printed, every day at 7.00. The switch-on is on 03.11.98 at 10.30. On
05.11.98 it is in the stop status from 2.00 to 8.30. It is also in the stop status
from 21.00 on 06.11.98 till 08.00 on 10.11.98. At 11.30 on 11.11.98 a different
speed is programmed for the printing recorder, using the setup program on a
PC. At 10.00 on 12.11.98 the instrument is switched off.
The recorder will print out the following reports:
The statistical period can be selected from “periodic”, “weekly”, “monthly” or
“external”. If monthly report is selected, it is printed out on the first day of each
month.
Time of
print-out
Statistical period
04.11.98 7:00 03.11.98 10:30 - 04.11.98 7:00
05.11.98 8:30 04.11.98 7:00 - 05.11.98 7:00
06.11.98 7:00 05.11.98 7:00 - 06.11.98 7:00
10.11.98 8:00 06.11.98 7:00 - 10.11.98 7:00
11.11.98 7:00 10.11.98 7:00 - 11.11.98 7:00
12.11.98 7:00 11.11.98 11:30 - 12.11.98 7:00
To Next Page
Loading...