JUMO LOGOPRINT 500 - External Relay Module ER8

93
10 Extra codes and accessories
10.3 External relay module ER8
The external relay module ER8 adds 8 switching outputs to the recorder.
The sequence of the relays 1 — 8 is permanently assigned to the limit compa-
rators 1 — 8 (limit state). The corresponding limit state is only transferred to
the relay if the relay has been activated (Configuration level 3
Î Relay output
Î Status = ON).
v Section 3.1 “Limit monitoring by limit comparators”
v Section 3.5.4
“Limit comparator texts, external text, binary-linked external text”
v Section 4.2 “Table of the configuration parameters”
H
The external realy module ER8 can only be operated when the
Extra Code has been installed in the recorder.
A
When the setup connector is plugged into the recorder, all relays
are de-energised.