EasyManua.ls Logo

Jungheinrich EJC 212-220 - Using the Truck for the First Time

Jungheinrich EJC 212-220
93 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
C 3
0606.GB
3 Using the truck for the first time
F
In order to disconnect the power supply immediately in an emergency, the battery
connector (not supplied) must be connected to the truck’s emergency disconnect.
The truck must not be operated without the emergency disconnect.
M
Only operate the truck with battery current. Rectified AC current will damage the
electronic components. The battery leads (tow cable) must be less than 6m long.
F
It is forbidden to raise loads if the truck is operated via a tow lead with an external
battery.
To prepare the truck after delivery or after transport, proceed as follows:
Check the truck for completeness and satisfactory condition of the equipment.
Install battery (where required). Do not damage battery cable.
(see chapter D).
Z
Set the characteristic curve (charging curve) on the charger (see Chapter D).
Charge the battery (see Chapter D).
If necessary, adjust the combination instrument to match the battery type (see
Chapter D).
Start up the truck as indicated.
(see Chapter E).
Z
When the truck is parked, the surface of the tyres will flatten. The flattening will
disappear after a short period of operation.
C 3
0606.GB
3 Using the truck for the first time
F
In order to disconnect the power supply immediately in an emergency, the battery
connector (not supplied) must be connected to the truck’s emergency disconnect.
The truck must not be operated without the emergency disconnect.
M
Only operate the truck with battery current. Rectified AC current will damage the
electronic components. The battery leads (tow cable) must be less than 6m long.
F
It is forbidden to raise loads if the truck is operated via a tow lead with an external
battery.
To prepare the truck after delivery or after transport, proceed as follows:
Check the truck for completeness and satisfactory condition of the equipment.
Install battery (where required). Do not damage battery cable.
(see chapter D).
Z
Set the characteristic curve (charging curve) on the charger (see Chapter D).
Charge the battery (see Chapter D).
If necessary, adjust the combination instrument to match the battery type (see
Chapter D).
Start up the truck as indicated.
(see Chapter E).
Z
When the truck is parked, the surface of the tyres will flatten. The flattening will
disappear after a short period of operation.

Table of Contents

Related product manuals