0606.GB
D 8
5 Battery removal and installation
– Expose the battery (see Section 3).
F
The truck must be parked on level ground. To prevent short circuits, batteries with
exposed terminals or connectors must be covered with a rubber mat. Place the
battery connector or the battery cable in such a way that they will not get caught on
the truck when the battery is removed.
Z
When transporting batteries using a crane, ensure that the crane is of adequate
capacity (the battery weight is indicated on the battery data plate on the battery
container). The lifting gear must exert a vertical pull so that the battery container is
not compressed. The hooks must be attached to the eyes of the battery in such a way
that they cannot fall onto the battery cells when the lifting gear is discharged.
– Attach the lifting gear to the attachment eyes and lift out the battery.
F
When replacing a battery always use the same battery type. Extra weights must not
be removed and must remain in the same position.
– Installation is the reverse order. When reinstalling the battery, note the proper
installation position and make sure the battery is connected correctly.
M
After installing the battery again, check all cables and plug connections for visible
signs of damage.
F
Before starting the truck, the battery panel must be firmly closed. Close the battery
panel carefully and slowly. Do not reach between the battery panel and the chassis.
5.1 Lifting the battery out from the top
– Open the battery panel.
– Disconnect the battery.
– Attach the crane lifting gear to the attachment eyes (8).
– Lift out the battery.
Installation is in the reverse order of removal. When reinstalling the battery, note the
required installation position and make sure the battery is connected correctly.
8
0606.GB
D 8
5 Battery removal and installation
– Expose the battery (see Section 3).
F
The truck must be parked on level ground. To prevent short circuits, batteries with
exposed terminals or connectors must be covered with a rubber mat. Place the
battery connector or the battery cable in such a way that they will not get caught on
the truck when the battery is removed.
Z
When transporting batteries using a crane, ensure that the crane is of adequate
capacity (the battery weight is indicated on the battery data plate on the battery
container). The lifting gear must exert a vertical pull so that the battery container is
not compressed. The hooks must be attached to the eyes of the battery in such a way
that they cannot fall onto the battery cells when the lifting gear is discharged.
– Attach the lifting gear to the attachment eyes and lift out the battery.
F
When replacing a battery always use the same battery type. Extra weights must not
be removed and must remain in the same position.
– Installation is the reverse order. When reinstalling the battery, note the proper
installation position and make sure the battery is connected correctly.
M
After installing the battery again, check all cables and plug connections for visible
signs of damage.
F
Before starting the truck, the battery panel must be firmly closed. Close the battery
panel carefully and slowly. Do not reach between the battery panel and the chassis.
5.1 Lifting the battery out from the top
– Open the battery panel.
– Disconnect the battery.
– Attach the crane lifting gear to the attachment eyes (8).
– Lift out the battery.
Installation is in the reverse order of removal. When reinstalling the battery, note the
required installation position and make sure the battery is connected correctly.
8
To Next Page
Loading...
