Juniper ACX7024 - Page 3

Connect an ACX7024 Router to Furuno TB-1 GNSS
Receiver and Install GNSS Antenna
IN THIS SECTION
Connect an ACX7024 Router to Furuno TB-1 GNSS Receiver | 3
Install the GNSS Antenna | 4
Gain and Noise Figure (NF) Calculaon | 4
Before you connect an ACX7024 router to the TB-1 GNSS receiver:
• Read "Install the GNSS Antenna" on page 4.
• Ensure that the following cables are available:
• Clock cables. See "Clock Cable Specicaons" on page 5.
• Antenna cables. See "Antenna Cable Specicaons" on page 7.
• Follow the instrucons in "Cabling Guidelines" on page 10.
Connect an ACX7024 Router to Furuno TB-1 GNSS
Receiver
To connect an ACX7024 router to a Furuno TB-1 GNSS receiver:
1. Connect one end of an RG-58 cable to the PPS connector port on the TB-1 GNSS receiver (labeled PPS) and the
other end of the cable to the 1PPS connector port on the ACX7024 router (labeled 1PPS IN).
2. Connect one end of an RG-58 cable to the 10-MHz connector port on the TB-1 GNSS receiver (labeled 10MHz) and
the other end of the cable to the 10-MHz connector port on the ACX7024 router (labeled 10MHz IN).
3. Use a USB-C to USB-C cable to connect one end of the cable to the data port (labeled DATA) on the TB-1 GNSS
receiver and the other end to the USB type C port on the ACX7024 router.
3