Juniper AP43 - Page 19

Figure 4: Universal Mounng Bracket (APBR-U) for Juniper Access Points
If you're mounng the AP on a wall, use screws with the following specicaons:
• Diameter of the screw head: ¼ in. (6.3 mm)
• Length: At least 2 in. (50.8 mm)
The following table lists the bracket holes that you need to use for specic mounng opons.
Hole Number Mounng Opon
1
• US single-gang juncon box
• 3.5 in. round juncon box
• 4 in. round juncon box
14