Juniper AP43 User Manual

• Connect an Ethernet cable from the data out port on the power injector to the Eth0+PoE port
on the AP.
• 12 V DC power supply
2. Wait for a few minutes for the AP to boot completely.
When the AP connects to the Juniper Mist portal, the LED on the AP turns green, which indicates
that the AP is connected and onboarded to the Juniper Mist cloud.
Aer you've onboarded the AP, you can congure the AP according to your network requirements.
See the Juniper Mist Wireless Conguraon Guide and Locaon Services Guide to congure your AP.
A few things to keep in mind about your AP:
• When an AP boots for the rst me, it sends a Dynamic Host Conguraon Protocol (DHCP)
request on the trunk port or nave VLAN. You can recongure the AP to assign it to a dierent
VLAN aer you've onboarded the AP (that is, the AP state shows as Connected in the Juniper
Mist portal. Ensure that you reassign the AP to a valid VLAN because, on reboong, the AP sends
DHCP requests only on that VLAN. If you connect the AP to a port on which the VLAN doesn't
exist, Mist displays a No IP address found error.
• We recommend that you avoid using a stac IP address on an AP. The AP uses the congured
stac informaon whenever it reboots, and you cannot recongure the AP unl it connects to the
network. If you need to correct the IP address, you'll need to reset the AP to the factory-default
conguraon.
If you must use a stac IP address, we recommend that you use a DHCP IP address during the
inial setup. Before assigning a stac IP address, ensure that:
• You've reserved the stac IP address for the AP.
• The switch port can reach the stac IP address.
35

Juniper AP43 Specifications

General

Brand	Juniper
Model	AP43
Category	Wireless Access Point
Language	English