4. Select 1) remove. You are prompted to enter a slot number.
5. Enter 1. The following message is displayed: It is now safe to remove the card from the
system!
6. Remove the interface module from the slot.
7. Plug the new or replacement interface module into the slot.
8. Press Enter.
9. Select 8) Card Swap menu.
10. Select 2) add. You are prompted to enter a slot number.
11. Enter a slot number from 1 to 6. The following message is displayed: Please make sure
the card is already physically inserted.
12. Press Enter. The following message is displayed: Card is inserted and the database is
populated to the card!
13. Quit the current menu session before resuming work by opening a new menu session.
Related
Documentation
• CTP2000 Serial Interface Modules on page 11
• CTP2000 T1/E1 Interface Module on page 12
Copyright © 2017, Juniper Networks, Inc.122
CTP2000 Hardware Documentation
To Next Page
Loading...
