a member ID in the range from 0 through 9 because there was already at least one
member of the Virtual Chassis configuration. The member ID is automatically assigned
to the new member switch's serial number in the configuration file.
Related Topics • Example: Expanding a Virtual Chassis Configuration in a Single Wiring Closet
• Example: Setting Up a Multimember Virtual Chassis Access Switch with a Default
Configuration
• Example: Configuring a Virtual Chassis Interconnected Across Multiple Wiring Closets
• Example: Configuring a Virtual Chassis Using a Preprovisioned Configuration File
• Example: Configuring Automatic Software Update on Virtual Chassis Member Switches
• Monitoring Virtual Chassis Configuration Status and Statistics
• Replacing a Member Switch of a Virtual Chassis Configuration (CLI Procedure) on
page 183
• Reverting to the Default Factory Configuration for the EX Series Switch
113Copyright © 2010, Juniper Networks, Inc.
Chapter 8: Planning the Virtual Chassis
To Next Page
Loading...
Need help?
General