Juniper EX4400 - Page 274

Pack an EX4400 Switch for Shipping
Before you pack the switch:
1. On the console or other management device connected to the switch, enter the CLI operaonal
mode and issue the following command to shut down the switch soware:
user@switch> request system halt
Wait unl a message appears on the console conrming that the operang system has halted.
2. Wrap and fasten one end of the ESD wrist strap around your bare wrist, and connect the other end
of the strap to a site ESD point.
3. Disconnect power from the switch.
4. Remove the cables that connect the switch to external devices.
5. Remove all opcal transceivers installed in the switch.
Ensure that you have the following parts and tools:
• Number 2 Phillips (+) screwdriver—not provided
• The original switch packing material (cardboard box, accessory box and its contents, and foam
padding)
• An ESD grounding strap—not provided
• Anstac bag—not provided
If you need to transport the switch to another locaon or return the switch to Juniper Networks, you
need to pack the switch securely in its original packaging to prevent damage during transportaon.
CAUTION: Do not pack the switch in anything except its original container, or the
switch might be damaged in transit.
To pack the switch:
1. Wrap and fasten one end of the ESD wrist strap around your bare wrist, and connect the other end
of the strap to a site ESD point.
2. If the switch is installed in a rack or cabinet, have one person support the weight of the switch
while another person unscrews and removes the mounng screws.
3. Remove the switch from the rack or cabinet and place the switch on a at, stable surface.
4. Use the screwdriver to remove the rack mounng brackets from the switch chassis.
266