Juniper EX4400 - Page 275

5. Place the switch in an anstac bag.
6. Place the boom poron of the packaging foam in the shipping carton.
7. Place the switch inside the cavity in the boom packaging foam.
8. Place the top poron of the packaging foam on top of the switch.
9. If you are returning accessories or eld-replaceable units (FRUs) with the switch, pack them as
instructed in "Pack EX4400 Switch Components for Shipping" on page 267
10. Place the accessory box by the rear end of the chassis in the shipping carton.
11. Close the top of the cardboard shipping box and seal it with packing tape.
12. Write the RMA number on the exterior of the box to ensure proper tracking.
Pack EX4400 Switch Components for Shipping
Ensure that you have the following parts and tools available:
• Anstac bag, one for each component—not provided
• An ESD grounding strap—not provided
If you need to transport a switch component to another locaon or return a component to Juniper
Networks, you need to pack the component securely in its original packaging to prevent damage during
transportaon.
CAUTION: Do not stack switch components. Return individual components in separate
boxes if they do not t together on one level in the shipping box.
To pack the switch components:
• Place individual components in anstac bags.
• Use the original packing materials if they are available. If the original packing materials are not
available, ensure the component is adequately packed to prevent damage during transit. The packing
material you use must be able to support the weight of the component.
• Ensure that the components are adequately protected by wrapping them well with packing materials.
Pack the component in an oversized box (if the original box is not available) with extra packing
material around the unit so that the component is prevented from moving around inside the box.
• Securely tape the box closed.
• Write the RMA number on the exterior of the box to ensure proper tracking.
267