Juniper EX4400 - Page 79

Table 36: Status LEDs on the RJ-45, SFP, and SFP+ Network Ports (Connued)
LED Color State and Descripon
Amber The speed indicators for EX4400-24MP and
EX4400-48MP are:
• On steadily—2.5 Gbps
• Blinking—5 Gbps
Blue The speed indicator for EX4400-24MP and
EX4400-48MP is:
• On steadily—10 Gbps
DX Green Indicates the duplex mode. The status indicators are:
• On steadily—The port is set to full-duplex mode.
• Unlit—The port is set to half-duplex mode.
EN Green Indicates the administrave status. The status indicators
are:
• On steadily—The port is administravely enabled.
• Unlit—The port is administravely disabled.
POE Green Indicates the PoE-bt mode for ports that support PoE-bt.
The status indicators are:
• On steadily—PoE-bt is enabled on the port, and a
device is drawing power.
• Blinking—PoE-bt is enabled on the port, but no power
is drawn from the port.
• Unlit—PoE-bt is not enabled on the port.
Table 37 on page 72 describes the beacon funconality on the status LEDs on the RJ-45, SFP, and SFP
+ network ports when you execute the request chassis beacon command.
71