Juniper Junos OS - Operational Commands

then {
destination-nat (off | pool pool-name | rule-session-count-alarm
(clear-threshold value | raise-threshold value));
}
}
}
}
proxy-arp interface interface-name address ip-address;
to ip-address;
}
proxy-ndp interface interface-name address ip-address;
to ip-address;
}
source {
address-persistent;
interface (port-overloading off | port-overloading-factor number);
pool pool-name {
address ip-address {
to ip-address;
}
address-persistent subscriber ipv6-prefix-length prefix-length;
address-pooling (paired | no-paired);
address-shared;
description text;
host-address-base ip-address;
overflow-pool (pool-name | interface);
pool-utilization-alarm (clear-threshold value | raise-threshold value);
port {
block-allocation {
active-block-timeouttimeout-interval;
block-size block-size;
log disable;
maximum-blocks-per-host maximum-block-number
}
deterministic {
block-size block-size;
host {
address ip-address;
address-name address-name;
}
no-translation;
port-overloading-factor number;
range {
port-low <to port-high>;
to port-high;
twin-port port-low <to port-high>;
}
}
routing-instance routing-instance-name;
}
pool-default-port-range lower-port-range to upper-port-range;
pool-default-twin-port-range lower-port-range to upper-port-range;
pool-utilization-alarm (clear-threshold value | raise-threshold value);
port-randomization disable;
rule-set rule-set-name {
description text;
91Copyright © 2016, Juniper Networks, Inc.
Chapter 11: Configuration Statements