Juniper Junos OS - Page 143

From zone: trust, To zone: untrust
Policy: p1, State: enabled, Index: 4, Scope Policy: 0, Sequence number: 1
Source addresses(excluded): as1
Destination addresses(excluded): as2
Applications: any
Action: permit
show security policies policy-name p1 detail (Negated Address)
user@host>show security policies policy-name p1 detail
node0:
--------------------------------------------------------------------------
Policy: p1, action-type: permit, State: enabled, Index: 4, Scope Policy: 0
Policy Type: Configured
Sequence number: 1
From zone: trust, To zone: untrust
Source addresses(excluded):
ad1(ad): 255.255.255.255/32
ad2(ad): 1.1.1.1/32
ad3(ad): 15.100.199.56 ~ 15.200.100.16
ad4(ad): 15.100.196.0/22
ad5(ad): 15.1.7.199 ~ 15.1.8.19
ad6(ad): 15.1.8.0/21
ad7(ad): 15.1.7.0/24
Destination addresses(excluded):
ad13(ad2): 20.1.7.0/24
ad12(ad2): 20.1.4.1/32
ad11(ad2): 20.1.7.199 ~ 20.1.8.19
ad10(ad2): 50.1.4.0/22
ad9(ad2): 20.1.1.11 ~ 50.1.5.199
ad8(ad2): 2.1.1.1/32
Application: any
IP protocol: 0, ALG: 0, Inactivity timeout: 0
Source port range: [0-0]
Destination port range: [0-0]
Per policy TCP Options: SYN check: No, SEQ check: No
show security policies global
user@host>show security policies global policy-name Pa
node0:
--------------------------------------------------------------------------
Global policies:
Policy: Pa, State: enabled, Index: 5, Scope Policy: 0, Sequence number: 1
From zones: zone1, zone2
To zones: zone3, zone4
Source addresses: any
Destination addresses: any
Applications: any
Action: permit
127Copyright © 2016, Juniper Networks, Inc.
Chapter 12: Operational Commands