Juniper Mesa - Page 11

2. Place the Li-Ion baery pack(s) in the compartment(s). Make
sure the connectors on the baery pack(s) line up with the
connectors inside the compartment(s).
3. Replace the door(s) and tighten the latches.
CAUTION: The Mesa is not totally sealed against water and
dust when baery doors are not installed and properly
latched.
4. Plug the AC wall power charger that came with the Mesa
into a wall socket. Plug the other end into the DC power
jack on the Mesa.
!
Ch 1 Getting Started 11