7. Install mounting screws into each of the open front-mounting holes aligned with the
rack, starting from the bottom, and secure them tightly.
8. On the rear of the chassis, slide the rear-mounting brackets on either side of the chassis
until the rear-mounting brackets contact the rack rails.
9. Install mounting screws into each of the open rear-mounting holes aligned with the
rack, starting from the bottom, and secure them tightly.
10. Visually inspect the alignment of the chassis. If the chassis is installed properly in the
rack, all the mounting screws on one side of the rack are aligned with the mounting
screws on the opposite side and the router is level. Figure 7 on page 8 shows the
router fully secured and installed in a four-post rack.
Figure 7: Router Installed in the Rack
Copyright © 2017, Juniper Networks, Inc.8
MX10003 3D Universal Edge Router Quick Start
To Next Page
Loading...
Need help?
General
