Juniper MX10008 - Unpacking the MX10008 Router and Components

To unpack the chassis (see Figure 48 on page 133):
Figure 48: Shipping Crate and Accessory Box
1. Move the shipping box to a staging area as close to the installation site as possible. While the chassis
is bolted to the pallet, you can use a forklift or pallet jack to move it. Make sure there is enough space
to remove components from the chassis.
2. Position the shipping box with the arrows pointing up.
3. Slice the nylon straps that hold the shipping boxes to the pallet with the box cutter or the packing knife.
4. Lift the shipping box off the chassis.
5. Remove the cardboard accessory box.
6. Remove the foam padding from the top of the box.
7. Remove the plastic cover from the router chassis.
133