CAUTION: See the heat symbol . The power supply surfaces are hot. Allow
a few minutes for the power supply to cool by pulling the power supply halfway out
of the chassis, or wear heat-resistant gloves while removing the power supply.
3. Peel back and remove the protective plastic wrap that covers all four sides of the power supply.
4. Ensure the power switch is set to the standby (O) position. This switch turns off the output voltage; it
does not interrupt DC.
5. Remove the plastic cable cover from the DC power input terminals by using the Phillips (+) screwdriver,
number 2, to loosen the screws (see Figure 118 on page 223).
Figure 118: Removing the Plastic Cable Cover on an MX10008 DC Power Supply
223
To Next Page
Loading...
