Juniper PTX10008 - Page 323

PTX10008 rear panel (see Figure 190 on page 327) and below PSU_9 on the PTX10016 rear panel (see
Figure 191 on page 327).
Figure 190: ESD Point on PTX10008 Chassis Rear
1—ESD point
Figure 191: ESD Point on PTX10016 Chassis Rear
3. Remove the appropriate fan tray (see “Removing a PTX10000 Fan Tray” on page 258).
4. Either remove the failing SIB (see “Removing a PTX10000 Switch Interface Board” on page 332) or
remove the cover by grasping each side of the plate and pulling straight out (see Figure 192 on page 328
for an example using the PTX10008).
327