Juniper PTX10008 - Page 338

Ensure that you have the following parts and tools available to remove a line card from a PTX10000 chassis:
•
ESD grounding strap
•
An electrostatic bag or an antistatic mat
NOTE: Placing a line card in an electrostatic bag might require a second person to assist with
sliding the line card into the bag.
•
Replacement line card or a cover for the empty slot
To remove a line card from a PTX10000 router chassis:
1. Place the antistatic bag or antistatic mat on a flat, stable surface.
2. Attach the ESD grounding strap to your bare wrist and connect the strap to the ESD point above the
status LEDs on the router chassis (see Figure 206 on page 342).
Figure 206: ESD Point on PTX10008 Chassis Front
g009684
1
1—ESD point
Figure 207: ESD Point on PTX10016 Chassis Front
g009764
1
1—ESD point
3. Label the cables connected to each port on the line card so you can reconnect the cables to the correct
ports.
342