4. Take the line card offline by issuing the following CLI command:
user@router> request chassis fpc slot slot-number offline
5. Unscrew the line card from the chassis by continually turning the handles to the left until the line card
is fully unseated. See Figure 208 on page 343.
Figure 208: Removing a PTX10000 Line Card
6. Using the handles, slide the line card halfway out of the chassis.
CAUTION: Do not stack line cards on top of one another or on top of any other
component. Place each line card separately in the electrostatic bag or on the antistatic
mat placed on a flat, stable surface.
CAUTION: Each PTX10000 line card weighs between 20.9 lb (9.5 kg) and 27.3 lb
(12.4 kg). Be prepared to support the full weight as you slide the line card out of the
chassis.
7. Grasp both sides of line card at midpoint and remove the line card from the chassis. Either have someone
assist you in putting the line card into the electrostatic bag or rest the card on the antistatic mat. Take
care not to bump or store the line cards on the connectors. See Figure 209 on page 344.
343
To Next Page
Loading...
