•
Phillips (+) screwdriver, number 2
To install the cable management system (see Figure 210 on page 345):
1. Open the shipping carton for cable management system and check that you have:
•
Two handle extensions
•
One cable tray
Figure 210: Cable Management System Components
2. Use the Phillips screwdriver to loosen and remove the screws on the two line card handles (see
Figure 211 on page 345).
Figure 211: Removing the Handle Screws
3. Replace the blue cap on the line card handle with the two handle extensions (see Figure 212 on page 346).
345
To Next Page
Loading...
