Juniper PTX10008 - Page 342

Figure 212: Adding Handle Extensions
g009778
4. Tighten the screws into the handle extensions.
5. Snap open the blue clips on the ends of the cable tray with your hands.
6. Place the cable tray across the front of the line card so that the two ends of the cable tray are under
the handle extensions.
7. Snap to close the blue clips of the cable tray around the handle extensions (see Figure 213 on page 346).
Figure 213: Adding the Cable Tray
g009779
8. Drape and tie the optical cables to the side (see Figure 214 on page 347). Another option is to drape
some of the cables under the handle extension and some cables over the handle extension.
346