Jura E80 - Rinsing the Fine Foam Frother; Cleaning the Fine Foam Frother

29
5 Maintenance
After each milk preparation, the E8 prompts you to perform a milk
system rinse.
E In programming mode, you can set whether the milk system
rinsing is to be prompted 10 minutes after preparation or
initiated automatically (see Chapter 4 ‘Permanent settings in
programming mode – Milk system rinsing’).
E This chapter applies to the professional fine foam frother and
the fine foam frother.
Precondition:‘Rinse the milk system’ is displayed.
T Place a receptacle under the fine foam frother.
T Press the ‘Pc’ button.
T Press the ‘>’ button.
T Press the ‘Rinse the milk system’ button to start the rinse
operation.
‘Milk system is being rinsed’ appears and the fine foam
frother is rinsed. The operation stops automatically.
To ensure that the fine foam frother always works properly, you
must clean it daily when you have been preparing milk.
Non-recommended cleaning agents will not optimally remove milk
residues. This may cause the cappuccino frother to become blocked
and fly off the machine. Discharge of hot steam.
T Use only original JURA milk system cleaner.
Harmful and irritating cleaning agent. Harmful if swallowed.
Irritating to eyes and skin.
T Keep children AWAY.
T Avoid contact with skin and eyes.
T After contact with skin, wash immediately with plenty of
water. In case of skin irritation, seek medical advice.
T After eye contact, immediately flush eyes with plenty of water
and seek medical advice.
T If swallowed, rinse mouth immediately and drink large
quantities of water. Do not induce vomiting. Seek medical
advice immediately and show label.
Rinsing the fine foam
frother
Cleaning the fine foam
frother
J WARNING
J WARNING